return_links() ); ?> getLinks(); ?> Get_Links(); ?> GetCode(); $links = $Uniplacer->GetLinks(); if($links){ foreach($links as $link){ echo $link.'
'; } } ?>

10:14. Removal and installation of the driveshaft

Design of the driveshaft of all-wheel drive models

1 — Samokontryashchayasya a nut
2 — the Rubber pillow
3 — the Remote plug

4 — the Driveshaft
— Replace N


Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!


2. The car also establish to Poddomkratta it on props.
3. The bent shaft consists of three sections: forward, back and central. Release nuts of fastening of the central basic bearing and accurately take the rubber pillows established under them.

Besides rubber pillows in fixture of the bearing also a number of remote plugs which number and the sizes can vary is used, - try to remember the adjusting provision of each of fixture elements.


4. Mark the provision of krepezhnogoflanets of a back collar of the driveshaft on a connecting flange of differential of the back bridge. Turn out fixing bolts and separate a shaft from differential, - try not to damage a protective cover.

For protection of a cover against damage in it it is possible to natolkat rags or the crumpled paper.

5. At extraction of the driveshaft from a case of the transfer case take care of preservation in an integrity and safety of an epiploon.
6. In order to avoid an oil effluence from the transfer case do not lower a car back on the earth. It makes sense to cork an opening in a case for the purpose of the prevention of hit in a dirt box.


Installation

 PERFORMANCE ORDER

1. Bring the driveshaft to the regular situation and fill it in a case of the transfer case (try not to damage an epiploon).
2. Having seen to correctness of combination of the landing tags put in the course of dismantle connect a shaft to a flange of back differential. Screw fixing bolts and tighten them with the required effort (30 ÷ 35 H • м).
3. Install the central basic bearing (see the Section Removal and installation of assembly of the central bearing of the driveshaft), - track correctness of installation of all elements of fixture of assembly. Screw fixing nuts and tighten them with the required effort (30 ÷ 35 H • м).
4. Check levels of liquids in the transfer case and a case of back differential.