10.9. Removal and installation of the executive cylinder of coupling



1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove the components located in a motive compartment and blocking access to assembly of the executive cylinder of coupling.
3. Disconnect the hydraulic line from assembly of the cylinder and lower working liquid in the prepared capacity.

The liquid merged from a path is not subject to reuse and has to be utilized according to regional laws on environmental protection. Remember also that hydraulic liquid is aggressive chemical compound and is capable to damage LKP at hit on the painted body surfaces!

4. Turn out fixing bolts and remove assembly of the executive cylinder from a transmission case (in case of need take the forelock and disconnect a cutting finger of a pusher from the lever).



1. Installation is made upside-down. Do not forget to grease all contact and basic knots.
2. Having finished assembly, "pump over" a hydraulic path, having completely removed from it air traffic jams (see the Section Removal of Air from a hydraulic path of the drive of switching off of coupling).