1. The car also establish to Poddomkratta it on props.
2. Remove back wheels.
3. Remove the brake drum.
4. Before starting dismantle of components, try to remember adjusting provisions of all springs and clamps.
5. Remove the top coupling spring.
6. Remove a spring of fastening of a boot to the regulator lever, then remove assembly of the regulator.
7. Remove clamps of the directing springs and dismantle brake boots, having disconnected from back a cable of the drive of the parking brake.

1. Carefully clear and dry a brake board, check smoothness of his speakers of contact surfaces, - existence of roughnesses is fraught with jamming of boots.
2. Grease contact surfaces of a board and anchor fingers of boots with lithium lubricant.
3. Remove and carefully clean other components of the brake mechanism. Grease a carving part of an adjusting castor with the anti-taking sealant and transfer all details to new shoe assemblies.
4. Connect to the corresponding boot a cable of the drive of the parking brake.
5. Fix boots on a brake board and, working as it should be the return to a dismantle order, install fixing components of brake assembly.
6. Adjust boots so that the brake drum sat down on them with an easy resistance (see the Section Adjustment of Drum Brake Mechanisms). Install the reel.
7. Screw a new stupichny nut and tighten it with the required effort (180 Nanometers).
8. Establish a protective cover of the wheel bearing and adjust boots of back brake mechanisms.

1. The car also establish to Poddomkratta it on props.
2. Remove back wheels and brake drums (see the Section Removal, installation and check of a condition of the brake drum).

3. Remove a spring of fastening of a boot to the regulator lever.

4. Remove the adjusting lever.

5. Remove assembly of the automatic regulator.

6. Remove the lower coupling spring.

7. Remove clamps and take the directing springs of boots.

8. Remove the top coupling spring.
9. Take off brake boots, - disconnect from the executive lever on a back boot a cable of the drive of the parking brake.

10. Remove the executive lever of the drive of the parking brake from an old boot.

1. Carefully wipe a brake board and process contact surfaces of persistent ledges special brake lubricant.

2. Transfer the executive lever of the drive of the parking brake to assembly of a new boot (back), - track correctness of installation of a wavy washer.

3. Clean assembly of the automatic regulator and accurately grease its carving part with special brake lubricant.
4. Connect a cable of the drive of the parking brake to the executive lever of a back boot.
5. Transfer assembly of a back boot to a brake board and establish the directing spring and an anchor finger.
6. Working in a similar manner, establish a forward boot on the regular place.
7. Place assembly of the regulator between boots.
8. Establish the top coupling spring.
9. Establish the lower coupling spring.
10. Install the regulator lever.
11. Establish a spring of fastening of a boot to the regulator lever.
12. Establish a returnable spring of the lever. Adjust boots and install the brake drum (see the Section Removal, installation and check of a condition of the brake drum).
13. Working in a similar manner, replace boots of the brake mechanism of an opposite wheel.
14. Establish wheels and lower the car on the earth.