1. Location and details of installation of assembly of ECU ABS is shown on illustrations.
2. Switch off ignition.

Ignition has to remain switched off during the whole time of implementation of the procedure.

3. On the Galant and Diamante models remove the left side panel of an upholstery of the luggage compartment.
4. On the Mirage models remove floor section of the central console.
5. Release a clamp in the lower part of the multicontact socket and disconnect an electrical wiring from the control unit (ECU) of ABS.
6. Give fixing nuts and remove ECU from the basic arm. In case of need the arm also to be dismantled by m.

1. If removed, establish into place a basic arm of the control unit.
2. Install the control unit and strongly tighten nuts of its fastening.
3. If removed, connect the grounding tire to an arm, - grounding has to be restored before connection to ECU of an electrical wiring. Make sure of reliability of fixing of the contact plug.
4. Connect the multicontact socket of an electrical wiring to the control unit, - track reliability of a zashchelkivaniye of a clamp.
5. Install the panel of an upholstery of luggage office / floor section of the central console.