11.6. Removal and installation of the valve regulator

Brake fluid is among aggressive chemical compounds and at contact with body panels destroys a paint and varnish covering. Before starting implementation of the procedure cover wings and the panel of a front of the car with special covers, or just old blankets.



1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Find the valve regulator which is usually located under assembly of GTTs.
3. Mark and disconnect the brake lines connected to the valve.
4. Remove the valve regulator and take it from a motive compartment of the car.



1. Installation is made upside-down.
2. In conclusion do not forget to pump over the brake system (see the Section Pumping of the Brake System).
3. Connect a negative wire to the battery and check serviceability of functioning of brakes.