1. The design of rack-mount assembly of a back suspension bracket of the Galant and Mirage models is shown on an illustration.
2. Remove rack-mount assembly from the car (see the Section Removal and installation of back racks).
3. The special tool squeeze a screw spring.
4. Remove a protective cover.
5. Holding a shock-absorber rod from a provorachivaniye, give самоконтрящуюся a nut.
6. Remove assembly of the top saddle of a spring with a slip.
7. Remove the metal plug, plugs A and B, a cup, the limiter of the course of compression and a dustproof casing.
8. Remove the compressed screw spring from the shock-absorber.

1. Install the compressed screw spring on the shock-absorber, - achieve hit of an end face of a bar of an extreme round of a spring in deepening in an overlay of a saddle.
2. Install on the shock-absorber a boot, the compression course limiter, a cup, metal and rubber plugs, a spring saddle with a slip.
3. Put on the top plug A and a washer a shock-absorber rod.
4. Screw new самоконтрящуюся a nut and temporarily tighten it.
5. Remove the tool squeezing a spring, then tighten finally самоконтрящуюся a nut with the required effort (25 H • м).
6. Establish a protective cover.
7. Establish assembly of the shock-absorber with a screw spring on the regular place on the car (see the Section Removal and installation of back racks).