1. At the corresponding complete set of the car make deactivation of a safety cushion for what bring forward wheels into rectilinear situation and take a key from the ignition lock (the column has to be blocked). Disconnect a negative wire from the battery and wind its contact tip with a high-quality insulating tape. Wait within not less than one minute during which the safety cushion remains active in the autonomous mode.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove a steering wheel (see the Section Removal and installation of a steering wheel).
3. Remove the cowl lock otpuskaniye handle.
4. Remove the switches located on the panel of a knee emphasis under a steering column, turn out the opened screws and dismantle an emphasis.
5. Remove the top and lower sections of a casing of a steering column.
6. If it is required, remove an air supply sleeve in a foot well, then accurately disconnect an electrical wiring from assembly of the switch of management of functioning of screen wipers.
7. Turn out fixing screws and remove assembly of the switch from a steering column.

1. Establish assembly of the switch on the regular place and connect to it the corresponding electrical wiring, - track reliability of a zashchelkivaniye of all provided clamps.
2. If removed, establish into place an air supply sleeve in a foot well.
3. Establish sections of a casing of a steering column and a knee emphasis.
4. Install the cowl lock otpuskaniye handle.
5. Make sure that forward wheels of the car remain in rectilinear situation and establish into place a steering wheel (see the Section Removal and installation of a steering wheel).
6. Connect a negative wire to the battery and turn the ignition key in position of ON, - on an instrument guard the control lamp of SRS has to join for seven seconds.
7. Check serviceability of functioning of the switch.