1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. The car also establish to Poddomkratta it on props. Remove the corresponding forward wheel.
3. Take the forelock and give a koronchaty nut of fastening of an external tip of steering draft on assembly of a rotary fist, - forelocks are subject to replacement without fail.

4. By means of a special stripper separate a tip from a rotary fist.

5. Mark the provision of a lock-nut concerning a tip.

6. One key holding a tip from a provorachivaniye, the second release its lock-nut, - the nut should be given on one whole revolution, no more!

7. Rotating a tip, remove it from a draft bar.

1. Smooth out a carving on a draft bar (the steering drive of forward wheels).
2. Screw a tip on a bar against the stop in a lock-nut, then turn off it on one whole revolution back and tighten a nut before combination of the adjusting tags put in the course of dismantle.
3. Fill a sharovy finger of a tip in a landing nest in assembly of a rotary fist, make sure that wheels are established in rectilinear situation, screw a koronchaty nut and tighten it with the required effort (34 H • м: the Mirage models and 29 H • м: the Galant and Diamante models). By pulling up (not an otpuskaniye) of a nut achieve combination of openings under installation of the forelock. Install the new forelock, having reliably parted its short moustaches.
4. Establish into place a wheel. Lower the car on the earth and tighten wheel nuts with the required effort (90 ÷ 110 H • м).
5. Connect a negative wire to the battery
6. Tighten a tip lock-nut with the required effort (42 H • м: the Mirage models and 49 ÷ 53 H • м: the Galant and Diamante models).
7. Check the angles of installation of forward wheels, in case of need make the corresponding adjustment.

1. The car also establish to Poddomkratta it on props.
2. Remove the corresponding forward wheel.
3. Take the forelock and give a koronchaty nut of a spherical finger of an external tip of steering draft.
4. A wire brush smooth out a carving of a bar of steering draft and moisten it with the getting oil.
5. By means of a stripper release a tip from a rotary fist.
6. Weaken a lock-nut and remove an external tip from a bar, - count quantity of turns on which the tip was will screw.
7. Release a lock-nut of fastening of thirst for rack transfer.
8. Release fixing collars and remove a corrugated protective cover of a case of the steering mechanism.
9. Unbend uvulas of a lock plate weaken a fixing nut and disconnect the internal end of a bar from assembly of rack transfer.

1. Having replaced a lock plate, establish draft and tighten it with the required effort (90 H • м).
2. Bend uvulas of a lock plate.
3. Establish into place a protective cover and fix it by new collars.
4. Establish an external tip of steering draft (see the previous subsection), - track that the tip was will screw precisely for the quantity of turns fixed in the course of dismantle.
5. Fix a tip in a rotary fist, screw and tighten a koronchaty nut of a spherical finger with the required effort.
6. Establish a wheel and lower the car on the earth.
7. Check the angles of installation of forward wheels, in case of need make the corresponding adjustment.