13:13. Removal and installation of door rear-view mirrors

Details of installation of a door rear-view mirror

1 — the regulator Handle
2 — the Triangular decorative cover
3 — the Protective cover

4 — the mirror Case
5 — the Mirror



1. Details of installation of door rear-view mirrors are shown on an illustration.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. Remove the internal triangular decorative panel.
4. On models with the manual drive of adjustment of provision of a mirror turn out the adjusting screw and remove the regulator handle.
5. On models with electrodriving mirrors disconnect the corresponding electrical wiring.
6. Give fixing nuts and remove a basic arm of door finishing.
7. Remove a mirror from the car.



1. Establish a mirror on the regular place.
2. Establish an arm of finishing and screw fixing nuts.
3. Depending on a design of the drive restore initial connection of an electrical wiring, or install the regulator handle.
4. Install the triangular decorative panel.
5. Connect a negative wire to the battery.
6. At the corresponding complete set check serviceability of functioning of the electric drive of a mirror.