3726b8fd

13:23. Removal and installation of door glass and regulator of a window regulator

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Lower door glass in extreme lower situation.
3. Remove the panel of an internal upholstery and the insulating screen of a door.
4. Hooking edge of a piece of fabric, carefully separate a tape molding from a doorframe.
5. Remove internal stabilizers of glass.
6. On forward doors remove the directing ram.

7. Prop up bottom edge of glass, then turn out two bolts of fastening of glass to the window regulator regulator, - not propped up glass can fail in a doorframe.

8. Accurately extract glass from a doorframe through a window opening.
9. Turn out bolts of fastening of the regulator.

10. At the corresponding complete set disconnect an electrical wiring from a window regulator drive electric motor.
11. Take the regulator through a special window of access in a doorframe.


Installation

 PERFORMANCE ORDER

1. Before installation moving elements of the regulator should be greased with universal lubricant slightly.
2. Install the regulator on the regular place and by hand tighten fixing bolts.
3. Since the left lower bolt and moving clockwise, make final tightening of fixture of the regulator.
4. At the corresponding complete set connect an electrical wiring to a driving electric motor.
5. Fill a windowpane in a doorframe and fix it on the regulator.

On the Hatchback models first of all the back support of glass, on models the sedan - a lobby drags on.

6. Slowly closing a window, check correctness of an arrangement of glass in a doorframe aperture. In case of need remove the regulator and slightly develop the openings provided in it under glass fastening bolts, - previously make sure that the distortion of glass is not connected with deformation of elements of the regulator.
7. Establish the other, being removed for the purpose of ensuring access doorframe components.
8. Connect a negative wire to the battery.