1. Details of installation of a back epiploon of a bent shaft are shown on an illustration.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. Remove transmission.
4. Remove assembly of a flywheel / a driving disk (see the Section Removal and installation of a flywheel / a driving disk).
5. Remove a back plate and a dome of transmission.
6. If leaks through a casing of a back epiploon take place, remove a casing. If a casing as it should be, just take from it an epiploon.

On some engines the separator which is also subject to removal is in addition established.

1. Grease internal sponges of a new epiploon with pure motive oil.
2. By means of special MD998376 adaptation press an epiploon in a casing against the stop, - track that the epiploon was not overwound. At the corresponding complete set put in a casing a separator (an oil opening down).
3. Apply sealant on the interfaced surface, replace sealing laying and install an epiploon casing on the block.
4. Establish assembly of a flywheel / a driving disk and transmission.
5. Connect a negative wire to the battery. Start the engine and check it for existence of signs of development of leaks.
6. Check the level of motive oil. In case of need make the corresponding adjustment (see the Head Nastroyki and routine maintenance).