7.18. Removal and installation of a starter

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Disconnect an electrical wiring from the measuring instrument of an air stream and remove a branch pipe of a sapun.
3. Give fixing nuts and remove an air inlet assembled with the resonator.
4. On the models equipped with an active suspension bracket like ECS disconnect an electrical wiring and an air-line from assembly of the air compressor. Turn out three bolts of fastening of the compressor on the chassis.
5. The car also establish to Poddomkratta it on props.
6. Remove elements of protection of a case.
7. On models of 1.5 l remove the thermofilter installed under the inlet pipeline.
8. In case of need disconnect a speedometer drive cable from transmission.

9. Disconnect an electrical wiring from a starter.

10. Turn out fixing bolts and remove a starter.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down. Track that fixing bolts were tightened with the required effort (31 H • м).
2. Connect a negative wire to the battery and check serviceability of functioning of system of start.