3726b8fd

10:11. Removal and installation of power shafts

Removal

 PERFORMANCE ORDER

1. Not poddomkrachivy the car, take forelocks and release stupichny nuts of forward wheels.

2. The car also establish to Poddomkratta it on props.
3. On the models equipped with ABS remove forward wheel sensors.
4. On the models equipped with the Active-ECS system release a nut of the nipple socket of fastening of the pneumatic line to the top part of a rack. Remove and will throw out a sealing ring. Turn out fixing bolts and remove the actuation mechanism of system from the top part of a rack. Disconnect the electrical wiring brought to the activator.
5. Release spherical support of the lower levers of a suspension bracket and tips of steering drafts from rotary fists.

6. Give stupichny nuts and remove washers.

7. At removal of assembly of a two-section left power shaft turn out bolts of fastening of the central basic bearing and remove the washers enclosed under their heads. By means of the stripper established from the outer side of stupichny assembly squeeze out of the last a pin of a power shaft (at the final stage the pin is beaten out by the hammer. Knocking-out of assembly of a shaft from differential of transmission is made by means of the hammer with soft brisk.

8. Release from transmission of assembly of a single-section right power shaft is made by a poddevaniye by its mount.

Attempts of a pulling of a shaft from differential are fraught with failure of the internal CV JOINT!


Installation

 PERFORMANCE ORDER

1. Replace the lock rings established on internal pins of power shafts.

2. Fill shaft in transmission, - track completeness of landing of pins.
3. Having delayed rack-mount assembly outside, fill an external pin of the corresponding power shaft in a nave.
4. Screw bolts of an arm of the central bearing and tighten them with the required effort (45 H • м).
5. Put on a shaft pin a washer (the party with chamfered outside). Screw a stupichny nut, however, do not tighten it still finally.
5. Put a spherical support in assembly of a rotary fist. Tighten a koronchaty nut of fastening of a spherical finger with the required effort (60 ÷ 72 H • l) also record it the new forelock.
6. Also put a tip of steering draft in assembly of a rotary fist, э the koronchaty nut of a spherical finger of the hinge drags on with effort 29 H • m and also is fixed by the new forelock.
7. On the equipped ABS models install into place wheel sensors.
8. On models with an active suspension bracket (Active-ECS) restore initial connection of the pneumatic line (do not forget to replace a sealing ring) and fix the activator of the actuation mechanism in the top part of a rack. Connect an electrical wiring.
9. Working in a similar manner, finish installation of the second power shaft.
10. Establish wheels and lower the car on the earth.
11. Tighten stupichny nuts with the required effort (145 ÷ 188 H • l) also record them new forelocks.