3726b8fd

12:16. Adjustment of wheel bearings

Mirage models

Replacement of wheel bearings is made assembled with naves!


 PERFORMANCE ORDER

1. The car also establish to Poddomkratta it on props. Remove the corresponding back wheel.
2. Remove a support and a disk of the brake mechanism / the brake drum (see the Head the Brake system).
3. Remove a dustproof cover and tighten a flange nut with effort 180 H • m.
4. By means of the dial measuring instrument of plunger type determine the size of an axial side play of the wheel bearing / ступичной assemblies. The maximum admissible value makes 0.05 mm.
5. By means of the dynamometer and a cord wound around heads of bolts measure effort of a provorachivaniye of the bearing / ступичной assemblies, - the maximum admissible value makes 19 N.
6. If results any of checks exceed the limit of admissible range, replace a nave.
7. Establish into place a dustproof cover.
8. Establish a brake disk with a support / the brake drum.
9. Establish a wheel and lower the car on the earth.


The Galant models for 1993 the issue.

On the models equipped with disk brake mechanisms of back wheels the naves of tight execution which are not needing adjustment are established. It is given the description of the procedure of adjustment of wheel bearings for models with drum back brake mechanisms below.


 PERFORMANCE ORDER

1. The car also establish to Poddomkratta it on props. Remove the corresponding back wheel.
2. Remove a dustproof cover and give a stupichny nut.
3. Rotating a nave / the brake drum, tighten a nut of the wheel bearing with effort 27 H • m.
4. Release an adjusting nut for removal of a pretightness of the bearing, then tighten it with effort 10 H • m again.
5. Block a nut and install the new forelock.
6. Establish into place a wheel and lower the car on the earth.


The Diamante and Galant models since 1994 of the issue.

 PERFORMANCE ORDER

By means of the dial measuring instrument of plunger type determine the size of an axial side play of the wheel hug bearing. The maximum admissible value makes 0.05 mm at the lock-nut tightened with the required effort. Adjustment of bearings on these models is not represented possible, - defective components are subject to replacement.