1. Having tracked hit of a spline in a reciprocal groove, put a damper of tortional fluctuations on a pin of a bent shaft, 2. On models of 1.5 l, 1.8 l, 3.0 l and 3.5 l screw the central bolt of fastening of a pulley and tighten it with the required effort (70 ÷ 100 H • m - for models of 1.5 l, 185 H • m - for models of 1.8 l and 3.5 l and 150 ÷ 160 H • m - for models 3.0 l). 3. On models of 1.5 l, 1.6 l, 2.0 l and 3.5 l screw bolts of fastening of a pulley to a shaft cogwheel. Tighten fixture with the required effort (14 H • m - for models of 1.5 l, 20 ÷ 30 H • m - for models 1.6 and 2.0 of l and 25 H • m - for models 2.4 l). 4. Establish into place a loker of protection of a wheel arch. 5. Establish a wheel, lower the car on the earth and tighten wheel nuts. 6. Establish belts of the drive of auxiliary units (see the Head Nastroyki and routine maintenance). 7. Connect a negative wire to the battery. |