4.1.21. Removal and installation of a flywheel / driving disk

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove transmission.
3. On models remove coupling assembly from RKPP (see the Head Stsepleniye and the transmission line).

4. Mark the provision of a flywheel / a driving disk of rather bent shaft and turn out fixing bolts.

5. On models remove the adapter of a driving disk from AT.

6. Remove a flywheel / a driving disk from the engine.


Installation

 PERFORMANCE ORDER

1. Grease fixing bolts with special sealant for fixing of threaded connections.

2. Connect assembly of a flywheel / a driving disk to a flange of a bent shaft.
3. On models with AT install the adapter of a driving disk.
4. Screw fixing bolts and tighten them with the required effort (135 H • м: for models of 1.5 l; 130 ÷ 140 H • м: for models of 1.6 l, 2.0 l and 2.4 l; 100 H • м: for models of 1.8 l and 53 ÷ 56 H • м: for models of 3.0 l and 3.5 l).
5. On models with RKPP establish into place coupling assembly (see the Head Stsepleniye and the transmission line).
6. Establish transmission.
7. Connect a negative wire to the battery.