4.1.9. Removal and installation of a radiator of the cooling system (all models)

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Empty the cooling system.

In order to avoid receiving burns, start performance of the listed works only after final cooling of system! Do not allow hit of antifreeze on open parts of the body and the painted surfaces of the car. Immediately wash away incidentally got splashes a plentiful amount of water. Remember that antifreeze is extremely toxic liquid and its hit in an organism even in small amounts is fraught with the most serious consequences (up to a lethal outcome). Never leave antifreeze stored in leaky closed container and immediately collect the cooling liquid spilled on a floor. Remember that the sweetish smell of antifreeze can draw to itself attention of children and animals. About ways utilization of the fulfilled cooling liquid consult at any station of car service. In many regions of the world special points on different reception of working off are equipped. Do not merge old cooling liquid in the sewerage and on the earth at all!

3. Disconnect an overflow tube (on some models it is also necessary to remove a broad tank).

4. Disconnect the top and lower radiator hoses.

5. Disconnect an electrical wiring from fans of cooling systems and air conditioning.

6. On the Mirage and Diamante models remove ventilatory assembly.

7. Disconnect an electrical wiring from the thermosensitive sensor.

8. On models with AT disconnect lines of cooling of ATF, - at once to a zakuporta the open ends of tubes and unions.

9. Remove the top support and take a radiator/radiator complete with ventilatory assembly.


Installation

 PERFORMANCE ORDER

1. Establish into place a radiator/radiator complete with ventilatory assembly.
2. Connect lines of cooling of ATF.
3. Connect an electrical wiring to the thermosensitive sensor.
4. If removed, establish into place ventilatory assembly.
5. Connect radiator hoses.
6. If removed, establish into place a basic arm of the air cleaner.
7. Install a broad tank of the cooling system and connect an overflow hose.
8. Fill the cooling system (see the Head Nastroyki and routine maintenance).
9. Connect a negative wire to the battery. Start the engine and warm up it up to the normal working temperature, then correct the level of cooling liquid in a radiator, on models with AT check the ATF level.
10. Wait for full cooling of the engine, then double-check the level of cooling liquid. In case of need make the corresponding adjustment.