3726b8fd

7.9. Removal and installation of the distributor of ignition (model with contactless system of ignition)

Removal

 PERFORMANCE ORDER

1. Bring the engine into the provision of VMT of the end of a step of compression of the piston of the first cylinder, - be guided on adjusting tags of cogwheels of the GRM drive (see the Head Dvigatel).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. At the corresponding complete set remove a protective cover of a plait of VV of an electrical wiring.
4. Disconnect an electrical wiring from the distributor, give a fixing bolt and take away an electrical wiring plait with the condenser connected to it aside.

5. Uncover the distributor with the wires connected to it by VV.
6. In case of need disconnect a bobbin wire.
7. Mark position of the runner concerning the case of the distributor and position of the case concerning the engine.

8. Give a clamping nut.

9. Carefully remove the distributor from the engine.


Installation

Adjusting tags are combined (the engine was not turned)

 PERFORMANCE ORDER

1. Having slightly oiled pure lubricating, install a new sealing ring on the distributor.
2. Install the distributor on the engine, - track correctness of combination of landing tags (the case and the runner). Make sure of completeness of landing of the distributor and introduction of its power shaft to gearing.
3. Screw a clamping nut.
4. Connect an electrical wiring to the distributor and record a plait a special bolt.
5. Install on the distributor a cover with the wires connected to it by VV.
6. Connect a negative wire to the battery.
7. Make adjustment of installation of a corner of an advancing of ignition (see the Section Check/adjustment of Installation of a Corner of an Advancing of Ignition), then finally tighten a clamping nut with the required effort (11 H • м).

Adjusting tags of a rassovmeshchena (the engine was turned at the removed distributor)

 PERFORMANCE ORDER

1. Install a new sealing ring on the distributor.

2. Bring the engine into the provision of VMT of the end of a step of compression of the first cylinder, - be guided on combination of adjusting tags of cogwheels of the GRM drive (see the Head Dvigatel). Track also that the tag on a damper of tortional fluctuations appeared opposite to a zero mark of a scale of the index.

3. Having tracked correctness of combination of the components of landing tags put in the course of dismantle, install the distributor on the engine, - the directing pin has to get to a reciprocal groove of a landing flange. Make sure of completeness of landing of assembly and that the runner will be deployed a nose towards an arrangement of the plug of the first cylinder on a cover (the landing tag was applied on a case rim at dismantle).