1. The car also establish to Poddomkratta it on props.
2. Prop up a jack a beam of the back bridge.
3. Give самоконтрящиеся fixing nuts and remove basic arms of the lower beam.
4. Turn out fixing bolts and remove assembly collars of a bar of the stabilizer of cross stability.
5. Holding a stabilizer bar from a provorachivaniye a wrench, give самоконтрящуюся a nut.
6. Remove basic cups and the rubber plug.
7. A wrench block a stabilizer rack from a provorachivaniye and release самоконтрящуюся a nut of its fastening. Working in a similar manner, disconnect the second rack.
8. Lower the jack which is propping up a beam of the back bridge, having left a small gap between a suspension bracket and a body of the car.
9. Take a bar of the stabilizer of cross stability from under the car.
10. Check a condition of a bar of the stabilizer and estimate degree of wear of components of its fastening.

1. Get a bar of the stabilizer of cross stability on the regular place and raise a jack a beam of the back bridge.
2. Connect to a bar of a rack of the stabilizer and fix them new самоконтрящимися by nuts, having tightened the last with effort 45 H • m.
3. Install the central plugs and collars of fastening of the stabilizer. Screw fixing bolts and tighten them with the required effort (14 H • м).
4. Return into place a cable of the drive of the parking brake, tighten an adjusting bolt of the wheel sensor.
5. Establish a basic arm of the lower beam, tighten a fixing bolt with effort 85 H • m, a nut - 130 H • m.
6. Establish new rubber pillows in beam arms, tighten new самоконтрящиеся nuts with the required effort (110 ÷ 130 H • м).
7. Lower the car on the earth.

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. The car also establish to Poddomkratta it on props.

3. Give самоконтрящиеся nuts of fastening of racks of the stabilizer of cross stability.

4. Turn out bolts of fastening of assembly collars, remove rubber plugs.
5. Remove a stabilizer bar from the car.
6. Check a condition of a bar of the stabilizer and estimate degree of wear of components of its fastening.

1. Get a stabilizer bar on the regular place.
2. Freely fix assembly collars.
3. Achieve the correct combination of adjusting marking, - the tags applied on a bar have to appear at distance about 10 mm from the outer edges of both assembly collars.
4. Having leveled a bar in a required way, tighten fixing nuts with the required effort (38 H • м).
5. Connect stabilizer racks to damping forks and a bar. Tighten fixing nuts with the required effort (38 H • м).
6. Lower the car on the earth.
7. Connect a negative wire to the battery.