3726b8fd

12:19. Removal and installation of the understeering combined switch

Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid getting injured at its casual operation (see the Head Onboard electric equipment). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation. In order to avoid damage of the SRS system, track that the steering shaft was not turned after removal of a steering wheel. Block a column the ignition key at the rectilinear provision of forward wheels.


Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. At the corresponding complete set of the car make deactivation of a safety cushion (see the Head Onboard electric equipment).
3. Remove a steering wheel (see the Section Removal and installation of a steering wheel).
4. On the Diamante models remove the cowl lock otpuskaniye handle.
5. Dismantle the knee emphasis located under a steering column. Remove the top and lower sections of a casing of a steering column.
6. On the Diamante models if it is required, remove knee having blown also in a sleeve of air supply in a foot well, then accurately disconnect an electrical wiring from assembly of the understeering combined switch.
7. On the Mirage models disconnect all electrical wiring, release a clamp and remove assembly of the understeering switch.
8. On the Galant models at the corresponding complete set turn out four screws of fastening to assembly of the understeering switch of the sliding contact ring of a tempostat. Turn out two fixing screws and remove the switch.


Installation

 PERFORMANCE ORDER

1. Establish assembly of the switch on the regular place and connect to it the corresponding electrical wiring, - track reliability of a zashchelkivaniye of all provided clamps.
2. Establish sections of a casing of a steering column and a knee emphasis.
3. If removed, establish into place an air supply sleeve in a foot well and knee having blown.
4. Make sure that forward wheels of the car remain in rectilinear situation and establish into place a steering wheel (see the Section Removal and installation of a steering wheel).
5. Connect a negative wire to the battery and turn the ignition key in position of ON, - on an instrument guard the control lamp of SRS has to join for seven seconds.
6. Check serviceability of functioning of the understeering switch.