3726b8fd

12:25. Removal and installation of the steering mechanism with the manual drive

Details of installation of the steering mechanism with the manual drive (Mirage model)

1 — the Bolt of fastening of a shaft of a steering column to an axis of a driving gear wheel of rack transfer
2 — the Collar
3 — the Forelock
4 — the Sharovy finger of a tip of steering draft
5 — the Assembly collar

6 — the Assembly collar
7 — the Case of the steering mechanism
8 — the Cover
— Replace N


Some of the cars considered in the present manual of model are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid getting injured at its casual operation (see the Head Onboard electric equipment). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation.


Mirage models

Removal

 PERFORMANCE ORDER

1. Details of installation of the steering mechanism on the Mirage models are shown on an accompanying illustration.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. The car also establish to Poddomkratta it on props. Remove forward wheels.
4. Disconnect an electrical wiring from the oxygen sensor and remove a reception pipe of system of production of the fulfilled gases.
5. Prop up/hang out the power unit. Give bolts of fastening of both jet emphasis of a suspension bracket of the unit.
6. Turn out four fixing bolts and remove the central beam.
7. Release a coupling bolt of fastening of the lower cardan hinge of a steering column to an entrance shaft of rack transfer, - previously mark the adjusting provision of components.
8. Take forelocks, give koronchaty nuts and release tips of steering drafts from rotary fists.
9. Release fixing bolts of assembly collars and take assembly of the steering mechanism with rubber pillows of its support through an arch of the right wheel.


Installation

 PERFORMANCE ORDER

1. Start assembly of the steering mechanism on the regular place, - track correctness of combination of the landing tags of shaft put in the course of dismantle.
2. Establish assembly collars and tighten bolts of their fastening with the required effort (70 H • м).
3. Tighten with the required effort (18 H • l) a coupling bolt of fastening of the lower shaft of a column to an entrance shaft of rack transfer.
4. Establish the central beam.
5. Establish a reception pipe of system of production of the fulfilled gases.
6. Connect an electrical wiring to the oxygen sensor.
7. Connect tips of steering thirsts for rotary fists, tighten koronchaty nuts with the required effort and record them new forelocks.
8. Check the angles of installation of forward wheels, in case of need make the corresponding adjustment.