return_links() ); ?> getLinks(); ?> Get_Links(); ?> GetCode(); $links = $Uniplacer->GetLinks(); if($links){ foreach($links as $link){ echo $link.'
'; } } ?>

14:12. Removal and installation of a combination of devices

The models of cars considered in the present manual are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid getting injured at its casual operation (see the Section System of Additional Safety (SRS) - the general information and precautionary measures). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation.


Mirage models

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove the central section of finishing of the dashboard.
3. Remove a knee emphasis.
4. Remove facing of an instrument guard.
5. Dismantle a combination of devices and remove from it the measuring instruments needing replacement / control lamps (see the Section Replacement of Measuring Instruments of a Combination of Devices).

At removal of a speedometer on models with the hummock drive of the last the nozzle of a cable is disconnected from the measuring instrument by its turning to the right or to the left.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down, - try not to damage the printed circuit board and measuring instruments of a combination of devices.
2. In conclusion connect a negative wire to the battery and check serviceability of functioning of all measuring instruments of an instrument guard.


Galant models

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Turn out two fixing screws, and carefully remove a combination peak from the dashboard.

3. Turn out four fixing screws and remove a combination of devices assembled with facing.

On some models need of a detachment from a combination of an electrical wiring is absent, - the printed circuit board is equipped with the shtyrevy sockets which are automatically connected at its installation.

4. Dismantle facing and remove the measuring instruments needing replacement / control lamps (see the Section Replacement of Measuring Instruments of a Combination of Devices).

At removal of a speedometer on models with the hummock drive of the last the nozzle of a cable is disconnected from the measuring instrument by its turning to the right or to the left.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down, - try not to damage the printed circuit board and measuring instruments of a combination of devices.
2. In conclusion connect a negative wire to the battery and check serviceability of functioning of all measuring instruments of an instrument guard.


Diamante models

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove switches and the handle of the drive of an otpuskaniye of the lock of a cowl from the knee emphasis located under a steering column. Turn out the opened screws and remove an emphasis.
3. Remove the top and lower sections of a casing of a steering column.
4. Remove facing of an instrument guard.
5. Dismantle a combination of devices and remove from it the measuring instruments needing replacement / control lamps (see the Section Replacement of Measuring Instruments of a Combination of Devices).

At removal of a speedometer on models with the hummock drive of the last the nozzle of a cable is disconnected from the measuring instrument by its turning to the right or to the left.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down, - try not to damage the printed circuit board and measuring instruments of a combination of devices.
2. In conclusion connect a negative wire to the battery and check serviceability of functioning of all measuring instruments of an instrument guard.